幕墙端面铣床:采用西门子电机高精度导轨及直线轴承，强度高，刚性好。气液压缸传动，运行平稳，无极调速，无爬行现象，加工光洁度好。使用操作方便，调整尺寸准确，铣切口精米<0.1MM。使用四把硬质量合金铣刀，一次在型材上铣出正确榫口。工作台面积大，一次可铣削10~12根型材，生产效率高适合批量生产。可根据客户要求，加装切断锯片。三个电机独立启动。可根据榫口要求选择工作电机。可铣削38~90系列窗料，隔热和幕墙料。铣削时带刀具自动喷冷系统。

Curtain end face milling machine: Adopt Siemens electric motor high-accuracy slide way and rectilinear axle bearing , intensity height , stiffness are fine. Make hydraulic pressure jar drive angry , run stable , poleless speed regulation , there be no crawl phenomenon , process smoothness well. The dimension using operation to go to the lavatory , adjusting is accurate , the bright metal cut is skill in <0.1 meter of MM. Use four the hard mass alloy milling cutter , once to be milled on the section bar outing the correct tenon mouth. Working table area is big , the once but bright metal cuts 10 ~ 12 section bars , efficacies highly to be fit to mass-produce. May demand according to the customer , add to pretend to break a saw bit up. Three electric motors get it in gear on one's own. May demand the electric motor choosing a job according to tenon mouth. May mill cutting 38 ~ 90 series windows material, heat insulation and curtain material. Bright metal takes a cutter to gush cold system voluntarily when chopping.

 工作气压 
  0.6~0.8MPA 
 
 耗气量
 200L/MIN 
 
电源 
 380V/50HZ
 
输入功率 
 3*2.2KW 
 
 铣刀转速
 2480R/MIN 
 
 铣刀尺寸
 Φ250* Φ50*6.5*40T
 
 工作台尺寸
 500*320MM 
 
 铣削行程
 950MM 
 
 外形尺寸（长*宽*高）
 2280*1040*1640MM 
 
 重量
 1300KG